Print Page - Model of a layer with unidirectional fibers

Title: Model of a layer with unidirectional fibers
Post by: Tabea Sterbak on May 28, 2021, 11:48:39 AM

Hi,
I wondered how to make a model of a layer with unidirectional fibers using ElastoDict. Is there a specific setting I could use?
Looking forward to your answer,
Tabea

Title: Re: Model of a layer with unidirectional fibers
Post by: Martina Hümbert on May 28, 2021, 01:58:30 PM

Hi Tabea,
under the "fiber Options" tab, set the Orientation for the fibers to "Given Directions" and enter the direction as vector.Or use "Angle in XY-Plane" and set the angle to e. g. 0°.

GeoDict Forum

Digital Material R&D => Structural Material Modeling and Analysis => Topic started by: Tabea Sterbak on May 28, 2021, 11:48:39 AM