Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Martina Hümbert

Pages: [1]
1
Hi Tabea,
The underlying algorithms: "Prohibit ..." creates non-overlapping fibers directly, while "Without ..." creates overlapping fibers first and removes the overlap afterwards. In most cases, "Without..." is better: Faster + higher SVF possible.
Regards
Martina

2
Basic functionality and features (GeoDict Base Package) / GAD-Object
« on: June 01, 2021, 11:55:03 AM »
Hi,
what is a GAD object?Thanks
Martina

3
ElastoDict / Plastic deformation
« on: June 01, 2021, 11:53:48 AM »
Hi,
can ElastoDict only solve linear-ealstic problems? Or can I also simulate plastic deformation?
Thanks
Martina

4
Modelling of foams / Anisotropic foam
« on: June 01, 2021, 11:51:53 AM »
Hi,
I want to make an anisotropic foam? How can I do that?
Thanks
Martina

5
FiberGeo / Error during generation of endless fibers
« on: June 01, 2021, 11:50:59 AM »
Hi,
I want to generate endless fibers in FiberGeo but GeoDIct gives the following error message: "A short fiber of maximal size might overlap with itself in a periodic domain." what do I have to do?
Thanks
Martina

6
Modelling of composites / Non-crimp farbic
« on: June 01, 2021, 11:49:26 AM »
Hi,
is there an easy way to generate a non-crimp fabric?
Thanks
Martina

7
Modelling of composites / Voids in a composite
« on: June 01, 2021, 11:48:40 AM »
Hi,
how can I add voids to the model of a composite?
Thanks
Martina

8
FiberFind / Segment by fiber diameter
« on: May 28, 2021, 02:02:46 PM »
Hi,
I have a fiber structure on which I ran FiberFind (analytic). The fibers have different diameters and I want to assign the fibers to different three classes depending on their diameter. Is there an easy way to do that?
Thanks
Martina

9
Hi Tabea,
under the "fiber Options" tab, set the Orientation for the fibers to "Given Directions" and enter the direction as vector.Or use "Angle in XY-Plane" and set the angle to e. g. 0°.

Pages: [1]