Setting "on deformed geometry" in FeelMathLD

· 2 · 5295
*

Tabea Sterbak

  • Math2Market Employee
  • *
  • Posts: 8
    • View Profile
  • Position: Scientific Temp at Math2Market
Setting "on deformed geometry" in FeelMathLD
« on: May 28, 2021, 11:30:33 AM »
Hi,
I was wondering what "Calculate on deformed geometry" (in the Macroscopic Load Case) in FeelMath-LD does for the calculation and when I should use it.
Looking forward to your answer,
Tabea


*

Sebastian Rief

  • Math2Market Employee
  • *
  • Posts: 8
    • View Profile
  • Position: Application Engineer at Math2Market
Re: Setting "on deformed geometry" in FeelMathLD
« Reply #1 on: June 07, 2021, 03:25:44 PM »
Hi Tabea,

With "on deformed geometry...", the resulting geometry of each deformation step is used as basis for the next step. In contrast, when "on deformed geometry..." is disabled, the original geometry is used as basis for each deformation step. "On deformed geometry..." can be understood as an iterative approach to consider nonlinear deformations. It must be used if new contacts occur and is useful for simulations where the geometry change is important.